Peerless PD12 Single Phase Air Compressor – Direct Drive – 1.5kW / 2.5HP – 12CFM/175LPM – Tank Mount

The PD12 is a great little unit delivering 175 litres of free air per minute, capable of running your framing and coil guns, it’s one of the largest direct drives on the market.
Fitted with a water trap filter regulator along with auto drain function (not manual drain like most) its ready to be set at 90PSI to run your air tools

This unit has also been designed that if you have the wheels removed you can mount directly to a base without having to chock up either ends.

Able to run;

• Low pressure spray guns
• Car tyre inflation
• Stapling / fitting gun
• Framing nail gun
• Grease gun
• Chalking gun
• Riveter gun

Did you know?

In standard environment conditions when your air compressor reaches 14 PSI you have the reached the volume of air in the receiver!. So on this particular model (PO13) at 14 PSI you have 30L of compressed air in the tank. At 28 PSI you now have 60L of compressed air in the tank. So if the cut out pressure is 112 PSI, you now have 240L of stored compressed air! Who said small tanks don’t hold enough air?
As mentioned this can be affected by the temperature and other factors.
Smaller tanks also equates to quicker air recovery times of lost pressure along with lower operating temperature of pump.

Important

Please note: air compressors i.e piston type, are not designed to run continuously they must cut in and out. Direct drive models should only have up to a 40-50% duty cycle. Belt Drive hobby models are up to 60-70% and full industrial belt drive models are up to 75-85%. If the compressor runs over these duty cycles it could cause failure. Important – first check voltage on each building site as low voltage will cause the motor to fail on all compressors. It must have be better than 230 volt at peak times. Extension leads will cause voltage drop, it’s better to use extra air hose.

Performance of all our belt driven air compressors are to AS4637.

For over 60 years Peerless Products has been delivering and exceeding the needs of industry. Ask us about your requirements.

Specification